![]() Draw a circle with center at the origin (at this point the size of the circle is not important, it will be adjusted in the next step), and then click on Generate. Click on the Modeling tab and you will notice that you have created Sketch 1 and Sketch 2.ģ Click on Sketch 1 and then click on the Sketching tab. ![]() Click again on the icon to create Sketch 2. Click on the icon corresponding to New Sketch to create sketch 1. Make sure that Major Grid Spacing is set to 5 cm, Minor Steps per Major is 5, and Snaps per Minor is 1. Select Grid and activate the buttons Show in 2D and Snap. ![]() A Sketching Toolboxes window will replace the Tree Outline window with a new set of tabs, select the Settings tab. Down below the Tree Outline window you will see the Sketching and Modeling tabs. Right click on icon corresponding to XYPlane and select look at. Create Geometry Set units to centimeters (cm) and click ok. This action will launch ANSYS Design Modeler (green logo DM). Back to the Project Schematic Window, click twice on the Geometry tab. Change the Analysis Type under the Advanced Geometry Options from 3D to 2D. Click twice on the lower tab and rename the project to Cylinder1 Now right click on the Geometry tab and select the properties option, a Properties of Schematic window will open. ![]() Left click on the tab corresponding to FluidFlow (FLUENT) and without releasing the mouse button drag the icon to the Project Schematic window (central big window). Starting ANSYS Workbench Click on the Start Menu, and then select Workbench Close Getting Started window. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |